Single command separate each range with a comma. You can define up to five port ranges on a Type, and the ports within a range cannot span the modules. A port range must consist of the same port You can either specify the ports or the name You can enter the port range in two ways: With the interface range command do not get Port range are saved to NVRAM, but the port ranges that are created Range using the define interface-range command.Īll configuration changes that are made to a Interface range command are applied to all theīefore you can use a macro, you must define a The VLANs that are notĭisplayed cannot be used in the interface range command. To display the VLAN SVIs, enter the show running config command. You can use the interface range command on the existing VLAN SVIs only. Support for extended VLAN addresses added. Support for this command was introduced on
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |